The CYC Photon mid-drive motor is a powerful and efficient motor that can give your bicycle a boost. If you're looking to install the CYC Photon mid-drive motor, you can do it yourself with the right tools and instructions. In this article, we'll provide a step-by-step guide to help you install the CYC Photon mid-drive motor on your bicycle.
Tools You'll Need:
Before you begin, it's important to gather all the necessary tools. Here's what you'll need:
- CYC Photon mid-drive motor kit
- Appropriate wrenches (usually 8mm, 10mm, and 14mm)
- Bottom bracket tool (for removing the bottom bracket)
- Allen keys (usually 4mm, 5mm, and 6mm)
- Torque wrench
- Electrical tape or heat shrink for any connections that need it.
How to install the CYC Photon mid-drive motor
Follow these steps to install the CYC Photon mid-drive motor on your bike:
Step 1: Remove the Pedals and Bottom Bracket
Use the appropriate wrenches and bottom bracket tool to remove the pedals and the bottom bracket from your bike. This will allow you to access the bottom bracket shell, which is where the CYC Photon motor will be installed.
Step 2: Install the CYC Photon Motor
Follow the manufacturer's instructions to install the CYC Photon motor onto the bottom bracket of your bike. Make sure to use the appropriate torque when tightening the bolts. It's important to position the motor properly, so be sure to follow the instructions closely. Use spacers if required so the motor doesn't touch the chainstay.
Step 3: Install the Chainring
The CYC Photon kit usually comes with a chainring already installed. If it's not installed, use the appropriate bolts to attach it to the ebike motor. Make sure it's tightened properly and aligned with the chain.
Step 4: Install the Cranks
To attach the cranks to the motor crank, you should use the appropriate bolts for the left and right sides. Make sure to tighten the bolts properly to secure the cranks in place.
Step 5: Install the Wiring
To connect the CYC Photon motor to the controller and battery, run the wiring according to the instructions provided. Make sure to follow the instructions closely to ensure proper installation. It is also important to use electrical tape to secure the wiring in place and prevent it from coming loose during use.
Step 6: Install the Battery
To attach the battery to your bike's frame, you should first consult the manufacturer's instructions for specific guidance. Make sure to follow these instructions carefully to ensure that the battery is attached correctly.
Step 7: Test the Motor
Once everything is installed, test the motor to make sure it's working properly. Check the torque sensor and the throttle, if your ebike conversion kit includes one. If there are any issues, troubleshoot them following the manufacturer's instructions.
Step 8: Adjust the Brakes and Gears
Adjust the brakes and gears on your bike as necessary. The CYC Photon motor may affect how these components work, so it's important to ensure they're adjusted properly.
With these steps completed, you should now have successfully installed the CYC Photon mid-drive motor onto your bike. Enjoy the ride! With the right tools, instructions, and a bit of patience, you can give your bike an upgrade that will take your cycling experience to the next level. Remember to follow the manufacturer's instructions closely and to take safety precautions when working with electrical components.
When it comes to upgrading your bike, the CYC Photon mid-drive motor is the right choice! You can also check our wide range of ebike mid drive conversion kits!