Cycling enthusiasts looking for a high-performance and reliable motor system to upgrade their bikes often turn to the Bafang BBSHD mid-drive motor kit. While professional installation services are available, many bikers choose to install the motor themselves with the right tools and instructions.
If you're up for the challenge, this step-by-step guide will walk you through the process of installing the Bafang BBSHD mid-drive motor on your bicycle.
Tools You'll Need:
Before you start, gather all the necessary tools. Here's what you'll need:
- Bafang BBSHD mid-drive motor kit
- Appropriate wrenches (usually 8mm, 10mm, and 14mm)
- Bottom bracket tool (for removing the bottom bracket)
- Bafang Tool - Provided in kit
- Allen keys (usually 4mm, 5mm, and 6mm)
- Crank puller tool
- Torque wrench
- Electrical tape or heat shrink for any connections that need it.
How to install the Bafang mid-drive motor
Here is our step by step guide to installing a Bafang BBSHD mid-drive motor kit:
Step 1: Remove the Pedals and Bottom Bracket
Utilise the suitable tools, such as a bottom bracket tool and wrenches, to eliminate the pedals and bottom bracket from your bike. This will permit you to gain access to the bottom bracket shell where the Bafang motor will be installed.
Step 2: Install the Bafang Motor
Install the Bafang motor onto your bike's bottom bracket according to the manufacturer's instructions. It's critical to ensure that the ebike motor is positioned accurately, so make sure to follow the instructions carefully. Use spacers, if necessary, to prevent the motor from touching the chainstay. Be sure to apply the appropriate torque when tightening the bolts. Over-tightening can lead to damage to the motor or frame, while under-tightening can cause the motor to loosen during use.
Step 3: Install the Chainring
The Bafang kit typically comes with a pre-installed chainring. If it's not pre-installed, use the appropriate bolts to attach it to the motor. Confirm that it's fastened securely and aligned with the chain.
Step 4: Install the Cranks
Fasten the Bafang cranks onto the motor crank's left and right sides using the appropriate bolts. Carefully follow the manufacturer's instructions to guarantee correct installation.
Step 5: Install the Wiring
Route the wiring from the Bafang motor to the battery and controller. Use electrical tape to secure the wiring in place and follow the instructions closely. Ensure that the wiring is positioned safely and doesn't come in contact with the bike chain or other moving parts.
Step 6: Install the Battery
Attach the battery to the bike's frame based on the manufacturer's instructions. Make sure that the battery is located in a safe and secure location where it won't interfere with the rider or bike's performance.
Step 7: Test the Motor
After completing the installation, test the motor to ensure that it's working correctly. If your ebike conversion kit includes a torque sensor or throttle, check them as well. If any issues arise, follow the manufacturer's instructions for troubleshooting.
Step 8: Adjust the Brakes and Gears
Adjust the bike's brakes and gears as necessary, as the Bafang motor may impact their performance. It's crucial to ensure that they're adjusted correctly.
With these steps completed, you should now have successfully installed the Bafang BBSHD mid-drive motor onto your bike. Enjoy the ride! With the right tools, instructions, and a bit of patience, you can give your bike an upgrade that will take your cycling experience to the next level.
When it comes to upgrading your bike, the Bafang BBSHD mid-drive motor kit is the right choice! You can also our wide range of ebike mid drive conversion kits!